021 8690 6777, 0812 1470 6170
0816 1740 8926 , 0816 1740 8891, 0878 7800 3233 , 0821 1170 1076
sales@rajaloadcell.com
Home   »   Produk   »   Force Gauge   »   Motorized Test Stands
  • weigh bridge load cell
  • Banner RLC1 kecil
  • Single Point Load Cell
  • Banner s-beam load cell
  • Banner RLC2 kecil
  • Single Point Load Cell
  • Commpresion Load Cell
  • Banner RLC3 kecil
  • Single Point Load Cell
  • Load Cell application
  • Banner RLC4 kecil
  • Torque sensor
  • Banner RLC1
  • Banner RLC2
  • Banner RLC3
  • Banner RLC4
  • Banner Force Gauge
  • Banner Cap Torque Tester
  • Banner Torque Tester
  • Torque Measuring Flange
  • Weighing Indicator
  • Seat Belt Load Cell
  • Indikator Timbangan
  • Digital Indikator

Motorized Test Stands MX2

 
 
 

Untuk memesan, silahkan tekan tombol ORDER. Anda bisa memesan barang secara Online.

 

Anda juga bisa memesan via telephone. Silakan hubungi sales consultant, Hotline kami di, 0878 7800 3233 , 0821 1170 1076 sales Consultant kami akan menjelaskan detail produk dan harga terbaru. atau email ke alamat sales@rajaloadcell.com

MX2 Vertical Motorized Test Stands use maintenance-free, brushless, DC motors that provide smooth and powerful operation to ensure consistent force testing results.

Precise Increment Mode
MX2 features a unique jog movement control, for precise increment testing. In jog mode, each click of the program dial moves the cross head approximately .015mm for MX2-110 and .01mm for MX2-275 (standard speed, under no load).

Cycle Mode
MX2 Program dial and LCD interface In cycle mode, automated fatigue tests are easy to setup. Press the unique program dial and turn, to make selections from the menu screens and set mode, speed, test duration, units and cycles. Control start and return speeds independently.

Force Control
Force controlled non-destructive tests are also easy to setup and program. Connect an Imada Z Series force gauge to the MX2 test stand to enable the following force controlled tests and Conditional Overload Prevention.

Maintain Force Between High/Low Setpoints
Initial cross head speed is controlled by the start speed setting. Force control activates when applied force exceeds the low setpoint (and below the high setpoint) on the Z Series force gauge. The cross head maintains that force for the programmed interval and then uses return speed to reset for the next cycle.

Increase Force to High Setpoint and Stop
Initial cross head speed is controlled by the start speed setting. When the applied force reaches the low set point of the Z Series force gauge, the test stand engages the measuring speed setting and stops when the applied force reaches the high set point on the Z series force gauge. Ideal for non-destructive or creep testing. The cycle is repeated until the counter limit is reached.